[Solved] Dimension-Parallel issue?
Posted: Sun Dec 31, 2017 8:51 am
Hi,
I have noticed following recently.
If I write a dimension using "Dimension Parallel" command, "Witness-Extension" is zero depending the orientation(angle) of the object.
This phenomenon is observed on "Dimension Diameter" command too.
See attached PDF.
Version: CADintosh 8.3 (Build 338), 8.3.2(Build 348)
Check it out, Bitte.
I have noticed following recently.
If I write a dimension using "Dimension Parallel" command, "Witness-Extension" is zero depending the orientation(angle) of the object.
This phenomenon is observed on "Dimension Diameter" command too.
See attached PDF.
Version: CADintosh 8.3 (Build 338), 8.3.2(Build 348)
Check it out, Bitte.